06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
39
X - Printadjust
AP 5.4
AP 5.6
The zero point of the mask is moved in relation to the edge of the label on the
X- axis, i. e. lengthways to the material.
If the setting is changed, while the print job is stopped, the printer
recalculates the format using the changed values.
Caution with graphics, which are generated via one of the Easy Plug
commands #YI, #YIR or #YIB! If the graphics is shifted beyond the label
border as a consequence of changing the parameter "X-Printadjust", the part
of the graphics which "juts out" will get lost.
x.x mm
Setting range: -15.0 to +15.0 mm; Unit interval: 0.1mm
Default setting: 0.0 mm
•
Maximum offset away from the edge of the label: +15.0 mm
•
No offset: 0.0mm
•
Maximum offset towards the edge of the label: -15.0 mm
Y – Printadjust
AP 5.4
AP 5.6
The zero point of the mask is moved in relation to the gap position on the Y-ax-
is, i. e. in the feed direction.
If the setting is changed, while the print job is stopped, the printer
recalculates the format using the changed values.
Caution with graphics, which are generated via one of the Easy Plug
commands #YI, #YIR or #YIB! If the graphics is shifted beyond the label
border as a consequence of changing the parameter "Y-Printadjust", the part
of the graphics which "juts out" will get lost.
x.x mm
Setting range: -15.0 to +15.0 mm; Unit interval: 0.1mm
Default setting: 0.0 mm
•
Maximum offset in feed direction: +15.0 mm
•
No offset: 0.0mm
•
Minimum offset against feed direction: -15.0 mm
Punch mode
AP 5.4
AP 5.6
Automatic
Automatic mode, for material with a contrast zone = gap in the label.
"Automatic" is the default setting, suitable for all materials with which there is
a difference in the transparency between the label and gap of more than 2
values (see Description, sensor check).
Manual
Manual setting, for material with several varying contrast zones. Settings are
made using the parameter
PRINT PARAMETER > Punch level
.
