06/15 Rev. 10
USER + SERVICE MANUAL
/Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
46
5061 Dispenser
motor
Status
The output stage board for the dispenser motor is not present or defective.
Measure
Press the Online button to acknowledge.
Check the output stage board for the dispenser motor and eventually
exchange it.
5062 Disp.
lift
motor
Status
The output stage board for the dispenser lift motor is not present or
defective.
Measure
Press the Online button to acknowledge.
Check the output stage board for the dispenser lift motor and eventually
exchange it.
5063 Press
roll
64-xx dispenser / DPM / PEM / ALX 92x
Status
The press roll lever is not closed. Opening the lever causes the immediate
deletion of all potentially queued status messages (e. g. ribbon end) and
display of the “Press roll” message. Closing the lever automatically
acknowledges the status message..
Measure
Close the press roll lever.
5063 Lever
open
AP
5.4/5.6
Status
The printhead lever is not closed. Opening the lever causes the immediate
deletion of all potentially queued status messages (e. g. ribbon end) and
display of the “Lever open” message. Closing the lever automatically
acknowledges the status message.
Measure
Close the printhead lever.
5064 Backing
paper
Status
Happens with dispenser version printers: Shows up, when the diameter of
the rewinded backing paper roll has become too large.
Measure
Clear the rewinding mandrel.
Press the Online button to acknowledge.
5071 Material
end
unw
Status
Occurs during operation with activated
internal
OD control. The message
appears, if the material roll diameter has reached the critical value (setable
by
MACHINE SETUP >Materialend err
).
Measure
Replenish the material roll.
