01/12 Rev. 5.07-01
USER MANUAL
Setup
AP 5.4 – AP 5.6
7
AP 5.4/AP 5.6 Standard
Inserting a label roll
1. Open the front hood.
2. Open the pressure lever [6A] on the print-
head.
3. Remove the guiding disk [6B] of the materi-
al roller.
4. If necessary, insert two properly fitting
adapter disks onto the unwinder.
Choose the spacing between the adapt-
er disks so that the roll of material is sup-
ported evenly.
5. Push the roll of material onto the unwinder.
Re-attach the guiding disk and push it up to
the roll of material.
The roll of material must rotate counter-
clockwise while unwinding!
6. Insert the material as shown [7].
Also make sure to push the material
around the material strain-relief [7A]!
7. Push the material guiding [8A] up to the
edge of the material without clamping the
material.
Continued overleaf.
[6] Preparing the material unwinder on AP 5.6.
[7] Inserting the label material.
[8] Adjusting the material guide (A).
A
B
C
A
A
