01/12 Rev. 5.07-01
USER MANUAL
Setup
AP 5.4 – AP 5.6
8
8. Push the sensor arm using the handle [9A]
until the indicator [9B] is above the punches
on the material.
The optional
reflex light sensor
is locat-
ed 6 mm to the right of the indicator!
9.
Direct thermal
printing: Close the pressure
lever.
Thermal transfer
printing: Insert rib-
bon, see chapter
Inserting Ribbon
on
page 11.
Inserting Leporello Fold
Alternatively to the roller material, you can also
use leporello fold (accordion fold):
1. Open the front hood.
2. Open the pressure lever on the printhead.
3. Place the leporello fold [10A] behind the
printer.
4. Push the material over the material unwind-
er. Push the guiding disk up to the edge of
the material without clamping the material.
5. Continue as described in steps 6 to 8 in
Inserting a label roll
on page 7.
Alternatively, the material can be fed
through the slot [10B] in the printer bottom.
[9] Adjusting the label sensor (figure w/o material).
[10] Inserting the leporello fold (A).
A
B
A
B
