06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
66
xxx KBytes
Setting range: 128 KBytes to the maximum size, which depends on the mem-
ory configuration and allocation of the printer; Unit interval: 128 KBytes; De-
fault setting: 256 KBytes
Switching the printer off extinguishes the memory content! Fonts, logos
etc., which were loaded on the RAM disk, must be loaded again after
switching the printer off.
Free store size
AP 5.4
AP 5.6
By setting this parameter, a part of the memory is reserved, which the printer
firmware can use if necessary (dynamic memory allocation). If this memory
area is dimensioned too small, the printer firmware can not work and the error
message „8856 Free store size“ shows up.
The more memory is allocated using this parameter, the less memory is
available for print jobs.
xxx KBytes
Setting range: 2048 KBytes to the maximum size, which depends on the
memory configuration and allocation of the printer; Unit interval: 128 KBytes;
Default setting: 2048 KBytes.
A good advice is to increase the set value step by step, starting with the mi-
nimum of 2048 KBytes, until the status message 8856 ("Free store size",
what means the memory area is low) does no longer appear during data con-
version.
Use with the Easy Plug command #YG, see manual
Easy Plug
.
See parameter
Memory status
on page 18.
Print info mode
AP 5.4
AP 5.6
Structure option for info printouts.
Par. values right
Setting for 100 mm material width. The parameter values are printed on the
right side of the parameter names:
Parameter name: Value
Par. values left
Setting for 100 mm material width. The parameter values are printed on the
left side of the parameter names:
Value: Parameter name
Compact right
Setting for 50 mm material width. The parameter values are printed on the
right side of the parameter names:
Parameter name: Value
Compact left
Setting for 50 mm material width. The parameter values are printed on the left
side of the parameter names:
Value: Parameter name
