NetApp CN1610, Cli Command Reference

Page: 279 / 708

276 sFlow Commands
no sflow receiver Use this command to set the sFlow collector parameters back to the defaults.
sflow receiver
owner timeout Use this command to configure a receiver as a timeout entry. As the sFlow
receiver is configured as a timeout entry, information related to sampler and
pollers are also shown in the running-config and are retained after reboot.
If a receiver is configured with a specific value, these configurations will not be
shown in running-config. Samplers and pollers information related to this
receiver will also not be shown in running-config.
Receiver Max
Datagram Size The maximum number of data bytes that can be sent
in a single sample datagram. The management entity
should set this value to avoid fragmentation of the
sFlow datagrams. The allowed range is 200 to 9116).
The default is 1400.
Receiver IP The sFlow receiver IP address. If set to 0.0.0.0, no
sFlow datagrams will be sent. The default is 0.0.0.0.
Receiver Port The destination Layer4 UDP port for sFlow
datagrams. The range is 1-65535. The default is
6343.
Parameter Description
Format
no sflow receiver indx {ip ip-address | maxdatagram
size | owner string timeout interval | port 14-port }
Mode Global Config
Format
sflow receiver index owner owner-string timeout
Mode Global Config
Field Description
index Receiver index identifier. The range is 1 to 8.