NetApp CN1610, Cli Command Reference

Page: 144 / 708

Chapter 4: Utility Commands 141
Transmit Packet Errors......................... 0
Collision Frames............................... 0
Number of link down events..................... 1
Time Since Counters Last Cleared............... 281 day 4 hr 9 min
0 sec
(CN1610) #show interface 0/1 | exclude “Packets”
Transmit Packet Errors......................... 0
Collision Frames............................... 0
Number of link down events..................... 1
Time Since Counters Last Cleared............... 20 day 21 hr 30 min
9 sec
show xxx |begin
“ string ”
The command xxx is executed and the output is filtered to show all lines
beginning with and following the first line containing the “ string ” match. All
prior lines are suppressed.
The following shows an example of the CLI command.
(CN1610) #show port all | begin “1/1”
1/1 Enable Down Disable N/A N/A
1/2 Enable Down Disable N/A N/A
1/3 Enable Down Disable N/A N/A
1/4 Enable Down Disable N/A N/A
1/5 Enable Down Disable N/A N/A
1/6 Enable Down Disable N/A N/A
(CN1610) #
show xxx |section
“ string ”
The command xxx is executed and the output is filtered to show only lines
included within the section(s) identified by lines containing the “ string ” match
and ending with the first line containing the default end-of-section identifier (i.e.
“exit”).
The following shows an example of the CLI command.
(CN1610) #show running-config | section “interface 0/1”
interface 0/1
no spanning-tree port mode
exit