16 - 12
Chapter 16 Troubleshooting
[2] Warnings
Types of warnings
Warnings detected by the Simple Motion module include system warnings, axis
warnings and warnings detected by servo amplifier.
(1) Simple Motion module detection system warnings
The types of system warnings are shown below.
System control data setting warnings
An axis warning for axis 1 will occur.
Positioning data setting warnings
An axis warning for each axis will occur.
Note that a warning will occur for the reference axis when an interpolation
designation or axis setting warning occurs.
(2) Simple Motion module detection axis warnings
Axis warnings occur due to setting warnings from operations such as
positioning operations, JOG operations or manual pulse generator operations.
Axis warnings occur due to system warnings.
The axis operation status does not change even if an axis warning occurs.
(3) Servo amplifier detection warnings
The warnings that occur when the hardware error of the servo amplifier or
servo motor occurs or the servo parameter is inapplicable.
The servo may not be turned off depending on the warning. However, an error
occurs or the operation cannot be executed normally if the warning is
remained.
When the warning cause is removed, warning is automatically released in the
servo amplifier. However, the state that the warning occurs is continued in the
Simple Motion module.
Reset it if necessary.
(4) Types of warning codes
Warning code
Classification of warnings
100 to 199
Common warnings
200 to 299
OPR warnings
300 to 399
JOG operation warnings
400 to 499
Manual pulse generator operation warnings
500 to 599
Positioning operation warnings
600 to 699
Synchronous control input axis warnings
700 to 799
Synchronous control output axis warnings
800 to 899
Cam data operation warnings
900 to 999
System control data setting range check warnings
2000 to 2999
Servo amplifier warnings
(The contents of warnings vary in the model of servo amplifier.)
61440 to 61695
Warnings for servo driver VCII series
61696 to 61951
Warnings for inverter
62464 to 62719
Warnings for servo driver VPH series
Summary of Contents for MELSEC-L Series
