Mitsubishi Electric GOT 1000 Series, Connection Manual

Page: 332 / 436

10 - 14
10. CONNECTION TO SHINKO TECHNOS INDICATING CONTROLLER
10.5 Indicating Controller Side Setting
10.5.4 Station No. settings
Set each station number so that no station number
overlaps.
The station number can be set without regard to the cable
connection order. There is no problem even if station
numbers are not consecutive.
(1) Direct specification
When setting the device, specify the station number of
the indicating controller of which data is to be changed.
(2) Indirect specification
When setting the device, indirectly specify the station
number of the indicating controller of which data is to be
changed using the 16-bit GOT internal data register
(GD10 to GD25).
When specifying the station No. from 100 to 115 on GT
Designer3, the value of GD10 to GD25 compatible to
the station No. specification will be the station No. of
the indicating controller.
(3) All station specification
Target station differs depending on write-in operation or
read-out operation.
• For write-in operation, all station will be a target.
In the WORD BIT write-in operation, only the
indicating controller whose station No. is the same as
host address is applicable. For details of host address
setting, refer to the following.
10.4.1 Setting communication interface
(Communication settings)
• In the read-out operation, only the indicating controller
whose station No. is the same as host address is
applicable.
For details of host address setting, refer to the
following.
10.4.1 Setting communication interface
(Communication settings)
Specification range
0 to 94
Specification
station NO.
Compatible
device
Setting range
100 GD10
0 to 94
For the setting other than the above, error
(dedicated device is out of range) will
occur.
101 GD11
102 GD12
103 GD13
104 GD14
105 GD15
106 GD16
107 GD17
108 GD18
109 GD19
110 GD20
111 GD21
112 GD22
113 GD23
114 GD24
115 GD25
GOT
Station
No.3 Station
No.7 Station
No.1 Station
No.15 Station
No.6
Examples of station number setting