Mitsubishi Electric GOT 1000 Series, Connection Manual

Page: 42 / 436

1 - 12
1. PREPARATORY PROCEDURES FOR MONITORING
1.1 Setting the Communication Interface

Setting item
The following describes the setting items for the standard I/F setting and extension I/F setting.
Item Description
Standard I/F Setting
Set channel No. and drivers to the GOT standard interfaces.
GT16, GT14, GT12: Standard I/F-1, Standard I/F-2, Standard I/F-3, Standard I/F-4
GT15, GT1030, GT1020: Standard I/F-1, Standard I/F-2
GT11, GT105 , GT104 : Standard I/F-1, Standard I/F-2, Standard I/F-3
CH No.
Set the CH No. according to the intended purpose.
The number of channels differs depending on the GOT to be used.
0: Not used
1 to 4: Used for connecting a controller of channel No. 1 to 4 set in Setting connected equipment (Channel
setting)
8: Used for barcode reader connection, RFID connection, PC remote operation connection, fingerprint
authentication device connection, printer (serial), or GOT (extended computer)
9: Used for connecting Host (PC)
*: Used for gateway function, MES interface function, and Ethernet download
Multi: Used for Ethernet multiple connection
I/F The communication type of the GOT standard interface is displayed.
Driver
Set the driver for the device to be connected.
None Host (PC) Each communication driver for connected devices
Detail Setting
Make settings for the transmission speed and data length of the communication driver.
Refer to each chapter of the equipment to be connected to the GOT.
RS232 Setting
To validate the 5V power supply function in RS232, mark the [Enable the 5V power supply] checkbox.
The RS232 setting is invalid in the following cases.
• CH No. of [I/F-1: RS232] is [9] in GT15 and 16.
• CH No. of [I/F-1: RS232] is [9] or [8] in GT14.
• For GT12, GT11 and GT10