Mindray WATO EX-65, Operator'S Manual

Page: 209 / 276

14-19
NOTE
z
Disassemble the bellows assembly before cleaning it. If not, it will take a very
long time to dry.
z
If autoclaving is necessary, assemble the bellows assembly first. Turn over the
bellows assembly to autoclave it.
1. Refer to the methods recommended in the table of
14.3 Clean&Disinfect and Re-install
the Breathing System
to clean and disinfect the bellows assembly.
2. Place the bellows assembly in warm (40 ℃ recommended temperature) mild detergent
(such as soap water). Carefully wash the assembly to prevent damage of the parts.
3. Rinse the assembly with clean warm water.
4. Autoclave the cleaned bellows housing. Maximum recommended temperature is 134ºC.
5. Hang the disinfected bellows assembly upside down and dry at a room temperature less
than 70
℃
.
6. Look for damaged parts after the bellows assembly is fully dry. Then install the
assembly with reference to
13.1.5Install the Bellows
.
7. Connect the bellows assembly, ventilator and breathing system.
8. Perform preoperative test before system use. For details, refer to
6.8.1 Bellows Test.
14.3.7 Sodalime Canister
NOTE
z
It is recommended to apply the high level disinfection procedure after the
intermediate level disinfection is completed.
1. Refer to the methods recommended in the table of
14.3 Clean&Disinfect and Re-install
the Breathing System
to clean and disinfect the sodalime canister.
2. Pour the sodalime into the sodalime canister when the canister is fully dry.
3. Refer to
13.1.8 Install the Sodalime Canister
to install the canister onto the breathing
system.