Mindray WATO EX-65, Operator'S Manual

Page: 129 / 276

9-5
9.5 Make AG Settings
By selecting the [
User Setup
] shortcut key and then [
Gas Module Setup >>
], you can make
AG settings described below.
9.5.1 Set Anesthetic Agent
As M-type AG module cannot identify the type of anesthetic agent automatically, you need to
set [
Agent
] to select the correct type of anesthetic agent before venting the anesthetic agent.
9.5.2 Set Pump Rate
In the [
Gas Module Setup
] menu, you can select [
Pump Rate
] and then select
either:[
High
],[
Med
] or [
Low
].
9.5.3 Set O2 Compensation
If the AG module is not integrated with O
2
module, you need to select to set O
2
compensation
based on the actual conditions. Access the [
Gas Module Setup >>
] menu and select [
O2
Comp
]. The options include:
„ [
OFF
]: when the amount of O
2
in the ventilation gas mixture is less than 30%;
„
Other options: selects an appropriate value according to the amount of O2 in the
ventilation gas mixture.
If the AG module is integrated with O
2
module, the system calculates compensation directly
using the O2 concentration detected by the O
2
module. In this case, [
O2 Comp
] is set to
[
OFF
] permanently and is not user adjustable.
9.5.4 Set Working Mode
The default working mode of the AG module is [
Measure
] when the anesthesia machine is
turned on. If the current AG module is Standby, you must push the key or select the
[
User Setup
] shortcut key
→
[
Gas Module Setup
>>]
→
[
Working Mode
]
→
[
Measure
]
to start the AG module. When the anesthesia machine restarts, the AG module automatically
continues with the previously selected working mode.