Mindray WATO EX-65, Operator'S Manual

Page: 226 / 276

B-4
Size 10.4"
Resolution 800 x 600 pixels
Brightness Adjustable
LED indication
Alarm lamp
One (yellow and red. When high and medium level alarms occur
simultaneously, it flashes red only)
AC power LED One (green; lit when connected to the AC power source).
Battery LED
One (green; lit when batteries are installed and AC power supply is
connected; flashing when powered by batteries; extinguished when no
batteries are installed or the anesthesia machine is switched off.)
Operating state LED One (green; lit when power-on and extinguished when power-off)
Audio indication
Speaker
Gives off alarm tones and key tones; supports multi-level tone
modulation. The alarm tones comply with the requirements of
IEC60601-1-8.
Buzzer Gives off alarm tones in case of equipment malfunction.
Connector
Power supply
One AC mains inlet
One or three auxiliary electrical outlets
One CIS power supply connector
Network
One multiplexing connector to support network, CIS and software
online upgrade. Implements data communication with the CIS through
HL7 protocol.
Equipotential One equipotential grounding terminal
B.5 Pneumatic Circuit System Specifications
ACGO
Connector
Male 22 mm conical connector incorporating a coaxial female 15
mm conical connector
Gas supplies
Pipeline pressure range 280 to 600 KPa
Pipeline connector NIST
Cylinder connector PISS
O2 control
Alarm of O2 supply failure Lower than 220 KPa