Mindray Imagyn 7, Operator'S Manual

Page: 446 / 492

G - 2 Operator’s Manual
G EMC Guidance and Manufacturer’s Declaration
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
NOTE:
• The system needs special precautions regarding EMC and needs to be installed and put into
service according to the EMC information provided below.
• Other devices may interfere with this system even though they meet the requirements of
CISPR.
• Preventing conducted RF immunity. Due to technological limitations, the conducted RF
immunity level are limited to 3 Vrms level, conducted RF interference above 3 Vrms may
cause wrong diagnosis and measurements. We suggest that you position system further from
sources of conducted RF noise.
• Portable and mobile RF communications equipment can affects system.
See Table G-1, Table G-2, Table G-3 and Table G-4 below.
If the system is operated within the electromagnetic environment listed in Table G-2 and Table
G-3, the system will remain safe and will provide the following basic performances:
•
Imaging;
• Doppler acoustic spectral displaying;
• Taking measurements;
• Patient information;
Date/time information.
Table G-1
GUIDANCE AND MINDRAY DECLARATION-ELECTROMAGNETIC EMISSIONS
The system is intended for use in the electromagnetic environment specified
below. The customer or the user of system should assure that it is used in such an
environment.
EMISSIONS TEST COMPLIANCE ELECTROMAGNETIC ENVIROMENT -
GUIDANCE
RF emissions
CISPR 11 Group 1 The system uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in nearby
electronic equipment.