Mindray Imagyn 7, Operator'S Manual

Page: 26 / 492

1 - 6 Operator’s Manual
1 Safety Precautions
• You should properly back up the system to a secure external storage media, including system
configuration, settings and patient data. Data stored to the system’s hard drive may be lost due
to system failure, improper operation or accident.
• Do not apply external force to the control panel. Otherwise, the system may be damaged.
• If the system is used in a small room, the room temperature may rise. Please provide proper
ventilation and free air exchange.
• To dispose of the system or any part, contact Mindray Customer Service Department or sales
representative. Mindray is not responsible for any system content or accessories that have been
discarded improperly.
• Electrical and mechanical performance may be degraded due to long usage (such as current
leakage or distortion and abrasion); the image sensitivity and precision may become worse too.
To ensure optimal system operations, it is recommended that you maintain the system under a
Mindray service agreement.
• To replace the fuse, contact Mindray Customer Service Department or sales representative.
• Do not turn OFF the power supply of the system during printing, file storage or invoking other
system operations. An interrupted process may not be completed, and can become lost or
corrupted.
• The iScape feature constructs a single extended image from a series of individual image
frames. The quality of the final image is user-dependent and requires skill to efficiently apply
the feature and technique. Exercise caution when measurements are performed from an iScape
image.
• Ensure that the current exam date and time are the same as the system date and time.
• Use detachable power supply cord as mains power breaking device. DO NOT set equipment in
place where difficult for disconnection of detachable power supply cord.
Please read the following precautions carefully to ensure the safety of the patient and the operator
when using the probes.
WARNING
• The ultrasound probe is only for use with the specified ultrasound
diagnostic system.
• The ultrasound probe must be used only by qualified professionals.
• Confirm that the transducer and probe cable are normal before and after
each examination. A defective probe may cause electric shock to the
patient.
• Do not subject the probe to shock. A defective probe may cause electric
shock to the patient.
• Do not disassemble the probe to avoid the possibility of electric shock.
• Never immerse the probe connector into liquids such as water or
disinfectant because the connector is not waterproof. Immersion may
cause electric shock or malfunction.
• A transducer sheath must be installed over the transducer before
performing examination.