Mindray DC-T6, Operator'S Manual

Page: 50 / 347

3-4 System Preparation
3.3 Power ON /OFF
3.3.1 Powering ON the System
CAUTION:
To ensure safe and effective system operation, you must
perform daily maintenance and checks.
If the system begins to function improperly – immediately
stop scanning. If the system continues to function improperly
– fully shut down the system and contact Mindray Customer
Service Department or sales representative.
If you use the system in a persistent improperly functioning
state – you may harm the patient or damage the equipment.
„ Checking before Power ON
To check the system before the system is turned on:
No. Check Item
<1>
The temperature, relative humidity and atmospheric pressure shall meet the
requirements of operating conditions. See "2.4.3 Environmental Conditions" for
details.
<2> There shall be no condensation.
<3>
There shall be no distortion, damage or dirt on the system and peripheral
devices.
If any dirt is found, cleaning shall be performed as defined in section “19.1.1
Cleaning the System”.
<4> There shall be no loose screws on the monitor or control panel.
<5>
There shall be no cable damage (e.g. power cord). Maintaining secure
connections to the system at all times.
<6>
The probes and probe cables shall be free of damage or stains.
See “13 Probes and Biopsy” for details on probe cleaning and disinfection.
<7>
No miscellaneous odds and ends are allowed to be attached or affixed to the
control panel.
<8>
Ensure that all connections are free from damage and remain clear of foreign
object blockages.
There shall be no obstacles around the system and its air vent.
<9>
Probe cleaning and disinfection. (Please refer to “13 Probes and Biopsy” for
details)
<10> The overall scanning environment and field must be clean.
<11> The locking mechanism of casters can work normally.
„ Turning on the Power
To turn on the system:
1. Toggle the circuit breaker at “On”.
2. The Ac power supply status indicator turns green.