Lenovo System x3650 M4 HD, Installation And Service Manual

Page: 100 / 1168

If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation”
on page 94.
Installing the 3x8 2.5-inch hot-swap HDD assembly kit
Use this information to add eight 2.5-inch hard-disk-drive bays in the server.
You can install an Lenovo System x3650 M4 HD 3x8 2.5-inch Hot-Swap HDD Assembly Kit to add eight
additional 2.5-inch hot-swap hard-disk-drive bays in the server. See http://www.lenovo.com/ serverproven/
for a list of supported optional devices. To order a 3x8 2.5-inch hot-swap HDD assembly kit, contact
your Lenovo sales representative or Lenovo reseller.
The 3x8 2.5-inch hot-swap HDD assembly kit contains the following components:
• Two hot-swap HDD backplanes
• One power cable
• One configuration cable
• One backplane power Y-cable
• One backplane configuration Y-cable
• Four mini-SAS cables (820 mm)
• Two mini-SAS cables (925 mm)
• Eight 2.5-inch HDD fillers
Note: The option including structural parts and Tier 1 parts.
To install the 3x8 2.5-inch hot-swap HDD assembly kit, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 2. Remove the cover (see “Removing the cover” on page 37).
Step 3. Remove the hard disk drives and filler panels from drive bay 8 to 15.
Figure 78. Drives, and filler panels removal
Step 4. Remove the two 4-drive filler panels from the right side.
Step 5. Disconnect all the cables connected from the expander.
Step 6. Remove the expander from the middle slot. Lift the expander out of the server by pulling it toward
the rear of the server and then lifting it up.
88
Lenovo System x3650 M4 HD Installation and Service Guide