The illustrations in this document might differ slightly from your hardware.
Removing and installing drives
Use this information to remove and install drives.
Read the safety information in “Safety” on page v and “Installation guidelines” on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
Depending on the server model, the server might come with a SATA attached DVD-ROM drive in bay 1.
The following illustrations show the location of the drive bays in the server. Your hardware might differ,
depending on the model.
Note:
If the server is configured for RAID operation using a ServeRAID adapter, you might have to
reconfigure your disk arrays after you install drives. See the ServeRAID adapter documentation for additional
information about RAID operation and complete instructions for using the ServeRAID adapter.
The following illustrations show the location of the drive bays in the 2.5-inch hot-swap SAS or hot-swap
SATA hard disk drive server models.
0
0
0
0
0
0
0
0
00
00
00
0000
00
00
0000
0000
0000
0000
0000
00
0
1
2
3
4
5
6
7
SATA/SAS hard disk drive bays
Figure 112. Server with eight 2.5-inch hard disk drives
Removing and replacing components
193
Summary of Contents for System x3500 M5 Type 5464
