Lenovo System x3500 M5 Type 5464, Installation And Service Manual

Page: 246 / 1236

Positive (+) side
To install the replacement battery, complete the following steps.
Step 1. Follow any special handling and installation instructions that come with the replacement battery.
Step 2. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite the battery clip.
Figure 151. Tilt the battery
b. Press the battery down into the socket until it clicks into place. Make sure that the battery clip
holds the battery securely.
c. If you removed a rubber cover from the battery holder, use your fingers to install the battery
cover on top of the battery connector.
Step 3. Install the air baffle (see “Replacing the air baffle” on page 189).
Step 4. Install and lock the left-side cover (see “Installing the left-side cover” on page 183).
Step 5. Reconnect the external cables and power cords; then, turn on the attached devices and turn on
the server.
Note: You must wait approximately 3 minutes after you connect the server power cord to an
electrical outlet before the power-control button becomes active.
Step 6. Start the Setup utility and reset the configuration:
a. Set the system date and time.
b. Set the power-on password.
c. Reconfigure the server.
See “Starting the Setup utility” on page 107 for details.
Removing the light path diagnostics assembly
Use the information to remove the light path diagnostics assembly.
Read the safety information in “Safety” on page v and “Installation guidelines” on page 29.
230
System x3500 M5 Installation and Service Guide