Provides the prefix of the message ID and the sequence number that is used by the CIM message
registry.
SNMP Trap ID
The SNMP trap ID that is found in the SNMP alert management information base (MIB).
Automatically contact Service
If this field is set to
Yes
, and you have enabled Electronic Service Agent (ESA), Support will be notified
automatically if the event is generated.
While you wait for Support to call, you can perform the recommended actions for the event.
User response
Indicates what actions you should perform to solve the event.
Perform the steps listed in this section in the order shown until the problem is solved. After you perform
all of the actions that are described in this field, if you cannot solve the problem, contact Support.
Note:
This list includes error codes and messages that might not apply to this machine type and model.
The following is the list of IMM2.1 error messages and suggested actions to correct the detected server
problems. For more information about IMM2.1, see the
Integrated Management Module II User's Guide
IMM Events that automatically notify Support
You can configure the Integrated Management Module II (IMM2) to automatically notify Support (also known
as
call home
) if certain types of errors are encountered. If you have configured this function, see the table for
a list of events that automatically notify Support.
Table 39. Events that automatically notify Support
Event ID
Message String
Automatically
Notify Support
40000086-00000000
Test Call Home Generated by user [arg1]. ()
Yes
40000087-00000000
Manual Call Home by user [arg1]: [arg2]. ()
Yes
80010202-0701xxxx
Numeric sensor [NumericSensorElementName] going low
(lower critical) has asserted. (CMOS Battery)
Yes
80010902-0701xxxx
Numeric sensor [NumericSensorElementName] going
high (upper critical) has asserted. (SysBrd 12V)
Yes
806f0021-2201xxxx
Fault in slot [PhysicalConnectorSystemElementName] on
system [ComputerSystemElementName]. (No Op ROM
Space)
Yes
806f0021-2582xxxx
Fault in slot [PhysicalConnectorSystemElementName] on
system [ComputerSystemElementName]. (All PCI Error)
Yes
806f0021-3001xxxx
Fault in slot [PhysicalConnectorSystemElementName] on
system [ComputerSystemElementName]. (PCI 1)
Yes
806f0108-0a01xxxx
[PowerSupplyElementName] has Failed. (Power Supply 1)
Yes
806f0108-0a02xxxx
[PowerSupplyElementName] has Failed. (Power Supply 2)
Yes
806f010c-2001xxxx
Uncorrectable error detected for
[PhysicalMemoryElementName] on Subsystem
[MemoryElementName]. (DIMM 1)
Yes
296
System x3500 M5 Installation and Service Guide
Summary of Contents for System x3500 M5 Type 5464
