Lenovo NeXtScale nx360 M5, Installation And Service Manual, Page: 49 / 1022

Select this choice to enable or disable UEFI to infinitely retry the legacy boot order. The default
is
Disable .
– BBS Boot
Select this choice to enable or disable legacy boot in BBS manner. The default is Enable .
– System Security
Select this choice to view or configure Trusted Platform Module (TPM) support.
– Integrated Management Module
Select this choice to view or change the settings for the integrated management module.
– Power Restore Policy
Select this choice to set the mode of operation after the power lost.
– Commands on USB Interface
Select this choice to enable or disable the Ethernet over USB interface on IMM. The default is
Enable .
– Network Configuration
Select this choice to view the system management network interface port, the IMM MAC address,
the current IMM IP address, and host name; define the static IMM IP address, subnet mask, and
gateway address, specify whether to use the static IP address or have DHCP assign the IMM2 IP
address, save the network changes, and reset the IMM.
– Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
– Reset IMM
Select this choice to reset IMM.
– Recovery
Select this choice to view or change the system recovery parameters.
– POST Attempts
Select this choice to view or change the number of attempts to POST.
• POST Attempts Limit
Select this choice to view or change the Nx boot failure parameters.
– System Recovery
Select this choice to view or change system recovery settings.
• POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
• POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
• Reboot System on NMI
Select this choice to enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs.
Enable is the default.
• Halt on Severe Error
Select this choice to enable or disable the system from booting into OS, displaying the POST
event viewer whenever a severe error was detected.
Disable is the default.
– Storage
Select this choice to view or change the storage device settings.
Chapter 2
.
Configuration information and instructions
35