Procedure
Step 1
Run the
display nqa-agent
[
admin-name
test-name
] [
verbose
] to view the status of the test
instance configured on the NQA client.
----End
Example
Using the
display nqa-agent
test-instance
admin-name
test-name
verbose
command, you can
view the uni-directional transmission delay threshold configured for the NQA test. For example:
<Quidway>
display nqa-agent
verbose
NQA Tests Max:2000 NQA Tests Number: 1
NQA Flow Max:1000 NQA Flow Remained:1000
nqa test-instance admin jitter
test-type jitter
destination-address ipv4 100.1.1.201
destination-port 80
send-trap probefailure
send-trap testfailure
send-trap testcomplete
send-trap rtd
send-trap owd-sd
send-trap owd-ds
threshold owd-sd 2000
threshold owd-ds 2000
nqa status : normal
6.33 Configuring the Trap Function
This section describes how to configure the trap function in an NQA test instance. After the trap
function is configured, a trap message is sent to the NMS in case of transmission success or
transmission failure.
6.33.1 Establishing the Configuration Task
6.33.2 Sending Trap Messages When Test Failed
A trap message is sent to the NMS when the transmission of NQA test packets fails.
6.33.3 Sending Trap Messages When Probes Failed
A trap message is sent to the NMS when the NQA test fails.
6.33.4 Sending Trap Messages When Probes Are Complete
A trap message is sent to the NMS when the NQA test is complete.
6.33.5 Sending Trap Messages When the Transmission Delay Exceeds Thresholds
A trap message is sent to the NMS when the test result exceeds the threshold.
6.33.6 Checking the Configuration
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-124
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
