This command can only be run on the administrator switch and the switch that does
not join any cluster.
Creating a cluster automatically
These steps need to be configured only on the administrator switch or on the switch which
will be the administrator in a created HGMP cluster.
In this mode, the administrator switch prompts you whether to add all the existing candidate
switches to the cluster.
1.
Run:
system-view
The system view is displayed.
2.
Run:
cluster
The cluster view is displayed.
3.
Run:
ip-pool
administrator-ip-address
{
mask-length
|
mask
}
The range of private IP addresses used in a cluster is set.
This command can be run only before the cluster is set up. If the cluster is set up, you
are not allowed to change the range of private IP addresses used in the cluster.
4.
Run:
auto-build
[
recover
]
A cluster is created automatically.
The
auto-build
command can also be used to add member switches automatically.
For configuration details, see
----End
8.2.5 Adding a Member Switch
To perform unified management over a switch that is not a member of a cluster, you must first
add the switch to the cluster.
Context
After a cluster is set up, you can add a member switch to the cluster either manually or
automatically.
Procedure
l
Adding a member switch manually
In this mode, you must manually specify the MAC address of the member switch.
Do as follows only on the administrator switch:
1.
Run:
system-view
The system view is displayed.
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-14
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
