Procedure
Step 1
Run the
display nqa results
command to view the test results on the NQA client.
----End
Example
Run the
display nqa results
command. If the test is successful, the following is displayed.
l
Statistics about errors
–
Number of unroutable connections
–
Number of wrong sequence numbers
–
Timeout times of the test packets
l
History statistics of each test packet
–
Timestamp added when each test packet is sent
–
Timestamp added when each test packet is received
–
Packets status displayed on the NQA client
l
Statistics of results of each test
–
Number of successful tests
–
Sum of the response time of all tests
–
RTT square sum
–
Minimum RTT and maximum RTT of the packet
–
Destination IP address and the type of the destination IP address
–
Number of the Echo packets and the sent packets
–
Time when the last packet is received
<Quidway>
display nqa results
NQA entry(admin, pwe3ping) :testflag is inactive ,testtype is pwe3ping
1 . Test 1 result The test is finished
Send operation times: 3 Receive response times: 3
Completion:success RTD OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Destination ip address:8.1.1.2
Min/Max/Average Completion Time: 4/6/5
Sum/Square-Sum Completion Time: 16/88
Last Good Probe Time: 2009-2-28 11:2:46.8
Lost packet ratio: 0 %
6.27 Configuring the PWE3 Trace Test to Check the One-
Hop PW
This section describes how to configure a PWE3 trace test to check the communications between
devices along a PW.
6.27.1 Establishing the Configuration Task
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-101
