NOTE
When all trap functions are enabled through the
snmp-agent trap enable
command or at least
three trap functions are enabled through the
snmp-agent trap enable feature-name
command:
l
you can run the
snmp-agent trap disable
command to disable all the enabled trap functions.
l
you can run any one of the
undo snmp-agent trap enable
and
undo snmp-agent trap
disable
commands to restore all trap functions to their default status.
l
To disable a specified trap function, you can run the
undo snmp-agent trap enable feature-
name
command.
----End
1.18.3 (Optional) Enabling the switch to Send an Alarm Message of
a Specified Feature to the NM Station
Context
Do as follows on the switch that requires an alarm to be enabled separately:
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
snmp-agent trap enable feature-name
feature-name
trap-name
trap-name
The switch is enabled to send an alarm message of a specified feature to the NM station.
To disable a specified trap function, you can run the
undo snmp-agent trap enable feature-
name
command.
----End
1.18.4 Configuring the Destination Host of Informing Messages
This part describes how to configure the destination address (IP address of the NM Station) for
trap messages.
Context
NOTE
When configuring the destination host, you must first ensure that the switch and the destination host are
reachable.
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1
Run:
system-view
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1 SNMP Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-63
