Example
If the NDP neighbor can be normally established, you can run the
display ndp
command to
check information about the MAC addresses of all the neighboring stations and the number of
the interface on the neighboring station that is connected to the local interface.
<Quidway>
display ndp
Neighbor discovery protocol is enabled.
Neighbor Discovery Protocol Ver: 1, Hello Timer: 60(s), Aging Timer: 180(s)
Interface: GigabitEthernet1/0/1
Status: Disabled, Packets Sent: 0, Packets Received: 0, Packets Error: 0
Interface: GigabitEthernet1/0/2
Status: Enabled, Packets Sent: 114, Packets Received: 108, Packets Error: 0
Neighbor 1: Aging Time: 174(s)
MAC Address : 0018-8203-39d8
Port Name :
GigabitEthernet1/0/1
Software Version: VRP 5.70 V100R003C00B051
Device Name : S9300
Port Duplex : FULL
Product Ver : S9300
If the NDP neighbor is normally established, you can run the
display ndp interface
command
to check information about the MAC address of the neighboring station and the number of the
interface on the neighboring station that is connected to the local interface.
<Quidway>
display ndp interface gigabitethernet 1/0/1
Interface: GigabitEthernet1/0/1
Status: Enabled, Packets Sent: 116, Packets Received: 110, Packets Error: 0
Neighbor 1: Aging Time: 174(s)
MAC Address :
0018-8203-39d8
Port Name :
GigabitEthernet1/0/1
Software Version: VRP 5.70 V100R003C00B051
Device Name : S9300
Port Duplex : FULL
Product Ver : S9300
If the NTDP neighbor is normally established, you can run the
display ntdp
command to check
the NTDP settings.
<Quidway>
display ntdp
Network topology discovery protocol is enabled
Hops : 3
Timer :
10 min
Hop Delay : 200 ms
Port Delay: 20 ms
Total time for last collection:462ms
If device information is successfully collected through NTDP, you can run the
display ntdp
device-list
[
verbose
] command to view information lists of all the devices.
<Quidway>
display ntdp device-list
The device-list of NTDP:
------------------------------------------------------------------------------
MAC HOP IP PLATFORM
------------------------------------------------------------------------------
0004-0004-0004 2 S9300
0003-0003-0003 1 S9300
0002-0002-0002 1 S9300
0001-0001-0001 0 S9300
If the cluster is established successfully, you can run the
display cluster
command to view
information about the HGMP cluster to which the device belongs, such as the cluster name and
ID of the management VLAN.
<HUAWEI_0.Quidway>
display cluster
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-18
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
