Step 3
Run:
test-type
lspping
The test type is set to LSP Ping.
Step 4
Run:
lsp-type
ipv4
The tunnel type is set to be the LSP tunnel.
Step 5
Run:
destination-address
ipv4
ip-address
{
lsp-masklen
masklen
|
lsp-loopback
loopback-
address
}*
The destination IP address to be tested is configured.
Step 6
(Optional) Perform the following as required to configure other parameters for the LSP Ping
test:
l
To configure the response mode of the Echo packet, run the
lsp-replymode
{
no-reply
|
udp
|
udp-via-vpls
|
udp-router-alert
|
level-control-channel
} command.
NOTE
In a uni-directional LSP Ping test, if the
lsp-replymode
no-reply
command is configured, the test
result displays that the test fails regardless of whether the test, actually, is successful or fails. If the test
is successful, the test result also displays the number of the timeout packets. If the test fails, the test
result displays the number of the discarded packets.
l
To configure the source IP address, run the
source-address
ipv4
ip-address
command.
l
To configure the packet size, run the
datasize
size
command.
NOTE
The sum of
datasize
and the size of the packet header should be less than the MTU of the interface;
otherwise, the test may fail.
l
To configure the maximum TTL value of the packet, run the
ttl
number
command.
l
To configure the LSP EXP value, run the
lsp-exp
exp
command.
l
To configure the padding character of the packet, run the
datafill
fillstring
command.
l
To configure the interval for sending test packets, run the
interval
seconds
interval
command.
l
To configure the percentage of the failed NQA tests, run the
fail-percent
percent
command.
Step 7
Run:
start
The NQA test is started.
Select the start mode as required because the
start
command has several forms.
l
To perform the NQA test immediately, run the
start
now
[
end
{
at
[
yyyy
/
mm
/
dd
]
hh
:
mm
:
ss
|
delay
{
seconds
second
|
hh
:
mm
:
ss
} |
lifetime
{
seconds
second
|
hh
:
mm
:
ss
} } ]
command.
The test instance is started immediately.
l
To perform the NQA test at the specified time, run the
start
at
[
yyyy
/
mm
/
dd
]
hh
:
mm
:
ss
[
end
{
at
[
yyyy
/
mm
/
dd
]
hh
:
mm
:
ss
|
delay
{
seconds
second
|
hh
:
mm
:
ss
} |
lifetime
{
seconds
second
|
hh
:
mm
:
ss
} } ] command.
The test instance is started at a specified time.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-47
