1.15.3 Checking the Configuration
After the maximum size of an SNMP packet is configured, you can view the configuration.
1.15.1 Establishing the Configuration Task
Before configuring the maximum size of an SNMP packet, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
In case that the NM Station obtains only partial status information about the switch, increase the
MTU of the SNMP packet.
Pre-configuration Tasks
Before configuring the maximize size of the SNMP packet, complete the following tasks:
l
Assigning an IP address to the switch
l
Configuring the routing protocol to make the switch and the NM Station accessible
Data Preparation
To configure the maximize size of the SNMP packet, you need the following data.
No.
Data
1
the maximum SNMP packets that the SNMP agent forwards
1.15.2 Configuring the Maximum Size of the SNMP Packet
The maximum size of an SNMP packet depends on the MTU of the network. If the size of an
SNMP packet exceeds the MTU of the network, the SNMP packet is fragmented.
Context
NOTE
If the maximum size is not specified, by default, 12000 bytes are sent or received.
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1 SNMP Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-47
