Authentication and encryption functions for the SNMP user group are configured.
----End
1.12.8 Checking the Configuration
After authentication and encryption mechanisms of SNMPv3 are configured, you can view
configurations of SNMP and ACLs.
Prerequisite
The configurations of the Authentication and Encryption Functions in SNMPv3 are complete.
Procedure
l
Run the
display snmp-agent group
[
group-name
]command to view the USM-based
group.
l
Run the
display snmp-agent usm-user
[
engineid
engineid
|
group
group-name
|
username
user-name
] * command to view information about users in the group.
l
Run the
display snmp-agent sys-info
version
command to view the SNMP version
information.
----End
Example
Run the
display snmp-agent group
command. If information on the USM-based group is
displayed, it means that the configuration succeeds.
<Quidway>
display snmp-agent group
Group name: a
Security model: v3 AuthnoPriv
Readview: ViewDefault
Writeview: <no specified>
Notifyview :<no specified>
Storage-type: nonVolatile
Run the
display snmp-agent usm-use
r command. If information on the SNMP user is displayed,
it means that the configuration succeeds.
<Quidway>
display snmp-agent usm-user
User name: b
Engine ID: 000007DB7F00000100000772 active
Run the
display snmp-agent sys-info version
command. If the version of SNMP run on the
Agent is displayed, it means that the configuration succeeds.
<Quidway>
display snmp-agent sys-info version
SNMP version running in the system:
SNMPv3
1.13 Configuring MIB-View-based Access Control in
SNMPv3
This section describes how to configure MIB-view-based access control in SNMPv3 to control
the NM Station to access the device.
1.13.1 Establishing the Configuration Task
1 SNMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1-40
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
