Pre-configuration Tasks
Before configuring community-name-based access control, complete the following tasks:
l
Assigning an IP address to the switch
l
Configuring the routing protocol to make the switch and the NM Station accessible
Data Preparation
To configure community-name-based access control, you need the following data.
No.
Data
1
ACL number
2
SNMP community name
1.5.2 Configuring the SNMP Version
By default, the NM Station accesses the device through SNMPv3. To enable the NM Station to
access the device through SNMPv1, you need to configure SNMPv1 on the device.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
snmp-agent sys-info version
v1
The SNMP version is configured.
By default, SNMPv3 is configured.
----End
1.5.3 Configuring a Basic ACL
This part describes how to configure the ACL to specify the IP address of the NMS allowed to
access the device.
Context
Do as follows on the switch enabled with the SNMP agent.
1 SNMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1-12
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
