1.7.5 Checking the Configuration
After MIB-view-based access control in SNMPv1 is configured, you can view configurations
of SNMP.
1.7.1 Establishing the Configuration Task
Before configuring MIB-view-based access control in SNMPv1, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
To set different authorities for NM Stations to access the switch, configure different MIB views
on the switch.
Pre-configuration Tasks
Before configuring MIB-view-based access control, complete the following tasks:
l
Assigning an IP address to the switch
l
Configuring the routing protocol to make the switch and the NM Station accessible
Data Preparation
To configure MIB-view-based access control, you need the following data.
No.
Data
1
SNMP community name
2
Information about MIB objects
1.7.2 Configuring the SNMP Version
By default, the NM Station accesses the device through SNMPv3. To enable the NM Station to
access the device through SNMPv1, you need to configure SNMPv1 on the device.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
snmp-agent sys-info
version
v1
The SNMP version is configured.
1 SNMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1-18
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
