6.10.3 Checking the Configuration
After configuring the traceroute test, you can view the test result.
6.10.1 Establishing the Configuration Task
Before configuring a traceroute test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
The NQA Traceroute test has a similar function with the
tracert
command except that the output
of the Traceroute test is more detailed.
Pre-configuration Tasks
Before configuring the Traceroute test, configure reachable routes between the NQA client and
the device to be tested.
Data Preparation
To configure the Traceroute test, you need the following data.
No.
Data
1
Administrator name and test name
2
Destination IP address
3
(Optional) VPN instance name, maximum hops, initial TTL and maximum TTL value
of the packet, and source IP address and destination port of the packet
4
Start mode and end mode of the test
6.10.2 Configuring Traceroute Test Parameters
This part describes how to set traceroute test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1
Run
system-view
The system view is displayed.
Step 2
Run:
nqa
test-instance
admin-name
test-name
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-25
