NOTE
The member switches in a cluster can communicate with the SNMP server in either of the
following modes:
l
Non-NAT: There must be reachable routes between member switches and SNMP server.
l
NAT: The
cluster-snmp-nat enable
command must be run in the cluster view to enable
the SNMP NAT function on the administrator switch. The NAT rules are automatically
generated on the administrator switch, and the member switches obtain the NAT mapped
ports.
The SNMP NAT function on the administrator switch is enabled by default. That is, the member
switches communicate with the SNMP server in NAT mode.
6.
Run:
logging-host
ip-address
A public log host is configured for the cluster.
Member switches can access the servers and hosts that are configured through Steps
3 to 6 by accessing the administrator switch.
Steps 3 to 6 are optional and are not listed in sequence.
By default, no public server and host is configured for a cluster.
----End
8.3.3 Managing Switches in a Cluster Through HGMP
You can use commands to configure the following features for member switches of an HGMP
cluster in batches: batch distribution, batch restart, incremental configuration, configuration
synchronization, and security features.
Procedure
l
Configuring the batch distribution function
Do as follows on the administrator switch:
1.
Run:
system-view
The system view is displayed.
2.
Run:
cluster
The cluster view is displayed.
3.
(Optional) Run:
cluster-plug-play ip
ftp-ip-address
username
user-name
password
password
[
path-separator
pathseparator
]
The default information for logging in to the FTP server is configured.
After the configuration, the configured information is used by default during the
process of batch distribution.
4.
(Optional) Run:
cluster-member ftp-timeout
time
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
