local-pw-type
local-pw-type
The PW type is set for the local device.
NOTE
This parameter can be configured only for PWE3 Ping and PWE3 Trace test instances. If the signaling
protocol of the tunnel is BGP, this parameter is always ethernet for PWE3 Trace instances and cannot be
changed.
l
Run:
lsp-exp
exp
The LSP EXP value is set for the NQA test instance.
NOTE
This parameter can be configured only for LSP Ping, LSP Trace, LSP Jitter, PWE3 Ping, and PWE3
Trace test instances.
l
Run:
lsp-replymode
{
no-reply
|
udp
|
udp-via-vpls
|
udp-router-alert
|
level-control-
channel
}
The reply mode of LSPs is configured for the NQA test instance.
NOTE
This parameter can be configured only for LSP Ping, LSP Trace, LSP Jitter, PWE3 Ping, and PWE3
Trace test instances.
l
Run:
lsp-tetunnel
tunnel
tunnel-number
The outgoing interface is configured for the NQA test instance.
NOTE
This parameter can be configured only for LSP Ping, LSP Jitter and LSP Trace test instances.
l
Run:
mtrace-source-address
ipv4
ip-address
The multicast source address is configured for the NQA MTrace test instance.
NOTE
This parameter can be configured only for MTrace test instances.
l
Run:
mtrace-last-hop-address
ipv4
ip-address
The last hop address is configured for the NQA test instance.
NOTE
This parameter can be configured only for MTrace test instances.
l
Run:
mtrace-group-address
ipv4
ip-address
The multicast group address is configured for the MTrace test instance.
NOTE
This parameter can be configured only for MTrace test instances.
l
Run:
mtrace-response-address
ipv4
ip-address
[
ttl
value
]
The response address, namely, the destination address of the IGMP Tracert Response
message, is configured for the MTrace test instance.
NOTE
This parameter can be configured only for MTrace test instances.
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-116
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
