No.
Data
3
(Optional) Name of a VPN instance, source IP address , number of test probes sent
each time, number of test packets sent each time, interval for sending test packets,
ratio of the failed NQA tests, and version number of jitter packets
4
Start mode and end mode
6.20.2 Configuring Parameters for the Path Jitter Test
This part describes how to set path jitter test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
nqa
test-instance
admin-name
test-name
An NQA test instance is created and the test instance view is displayed.
Step 3
Run:
test-type
pathjitter
The type of the test instance is configured as path jitter.
Step 4
Run:
destination-address
ipv4
ip-address
The destination IP address is configured.
Step 5
(Optional) Run the following commands to configure other parameters for the path jitter test:
l
Run:
icmp-jitter-mode
{
icmp-echo
|
icmp-timestamp
}
The mode of the path jitter test is configured.
l
Run:
vpn-instance
vpn-instance-name
The VPN instance to be tested is configured.
l
Run:
source-address
ipv4
ip-address
The source IP address is configured.
l
Run:
probe-count
number
The number of test probes to be sent each time is set.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-69
