Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
nqa
test-instance
admin-name
test-name
An NQA test is created and the view is displayed.
Step 3
Run:
test-type
http
The test type is set to HTTP.
Step 4
Run:
destination-address
ipv4
ip-address
The destination IP address is configured.
Step 5
(Optional) Perform the following as required to configure other parameters for the HTTP test:
l
To configure the VPN instance to be tested, run the
vpn-instance
vpn-instance-name
command.
l
To configure the source IP address, run the
source-address
ipv4
ip-address
command.
l
To configure the source port, run the
source-port
port-number
command.
l
To configure the destination port, run the
destination-port
port-number
command.
l
To configure the percentage of the failed NQA HTTP tests, run the
fail-percent
percent
command.
l
To configure the NQA test packet to be sent without searching the routing table, run the
sendpacket passroute
command.
Step 6
Run:
http-operation
{
get
|
post
}
The HTTP operation type is configured.
By default, the HTTP operation type is Get.
Step 7
Run:
http-url
deststring
[
verstring
]
The web page to be visited and the HTTP version are configured.
NOTE
Run the
http-url
deststring
[
verstring
] command and enter the name of the web page directly. If the input
content contains http:// and the domain name, the test may fail.
When information on the HTTP version is not configured, by default, HTTP1.0 is supported. HTTP1.1 can
be supported through your configurations.
Step 8
Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-20
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
