Procedure
Step 1
Run the
display nqa results
[
test-instance
admin-name
test-name
] command to view the test
results on the NQA client.
----End
Example
Run the
display nqa results
command. If the test is successful, the following is displayed.
<Quidway>
display nqa results
NQA entry(admin, snmp) :testflag is inactive ,testtype is snmp
1 . Test 1 result The test is finished
Send operation times: 3 Receive response times: 3
Completion:success RTD OverThresholds number: 0
Attempts number:0 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Destination ip address:10.2.1.2
Min/Max/Average Completion Time: 63/172/109
Sum/Square-Sum Completion Time: 329/42389
Last Good Probe Time: 2006-8-5 15:33:49.1
Lost packet ratio: 0 %
6.12 Configuring the TCP Test
This section describes how to configure a Transmission Control Protocol (TCP) test to check
the responding speed of a TCP port.
6.12.1 Establishing the Configuration Task
6.12.2 Configuring the TCP Server
6.12.3 Configuring the TCP Client
This part describes how to set TCP test parameters.
6.12.4 Checking the Configuration
After configuring the TCP test, you can view the test result.
6.12.1 Establishing the Configuration Task
Before configuring a TCP test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
To obtain the time for the specified port to respond to a TCP connection request, you can create
an NQA TCP test instance.
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-30
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
