The system view is displayed.
Step 2
Run:
nqa
test-instance
admin-name
test-name
An NQA test instance is created and the test instance view is displayed.
Step 3
Run:
test-type
ftp
The test type is set to FTP.
Step 4
Run:
destination-address
ipv4
ip-address
The destination IP address is configured.
Step 5
(Optional) Perform the following as required to configure other parameters of the FTP Download
test:
l
To configure the source IP address, run the
source-address
ipv4
ip-address
command.
l
To configure the VPN instance to be tested, run the
vpn-instance
vpn-instance-name
command.
l
To configure the FTP source port number, run the
source-port
port-number
command.
l
To configure the FTP destination port number, run the
destination-port
port-number
command.
l
To configure the NQA test packet to be sent without searching the routing table, run the
sendpacket passroute
command.
Step 6
Run:
ftp-operation
get
The FTP operation type is set to Get.
By default, the FTP operation type is Get.
Step 7
Run:
ftp-username
name
The FTP user name is configured.
Step 8
Run:
ftp-password
password
The FTP password used during the login is configured.
Step 9
Run:
ftp-filename
file-name
The name of the file to be downloaded is configured.
NOTE
During the FTP test, select a file with a relatively small size for the test. If the file is large, the test may fail
because of timeout.
Step 10
Run:
start
The NQA test is started.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-13
