Context
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the
display nqa results
command to view test results. By the default, the command output contains the records about only the last
five test results.
Procedure
Step 1
Run the
display nqa results
[
test-instance
admin-name
test-name
] command to view the test
results on the NQA client.
----End
Example
Run the
display nqa results
command. If the following is displayed, it means that the test is
successful.
l
"testFlag is inactive"
l
"The test is finished"
l
"Completion:success"
For the ICMP test, you can also view the minimum time, maximum time, and RTT(Round Trip
Time ).
<Quidway>
display nqa results
NQA entry(admin, test) :
testflag is inactive
,testtype is icmp
1 . Test 1 result
The test is finished
Send operation times: 3 Receive response times: 3
Completion:success
RTD OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Destination ip address:10.112.58.3
Min/Max/Average Completion Time: 2/5/3
Sum/Square-Sum Completion Time: 9/33
Last Good Probe Time: 2010-06-21 15:33:09.2
Lost packet ratio: 0 %
6.6 Configuring the FTP Download Test
This section describes how to configure a File Transfer Protocol (FTP) download test to check
the FTP download performance.
6.6.1 Establishing the Configuration Task
6.6.2 Configuring the FTP Download Test Parameters
This part describes how to set parameters for the FTP download test.
6.6.3 Checking the Configuration
After configuring the FTP download test, you can view the test result.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6 NQA Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-11
