No.
Data
3
FTP user name and password
4
(Optional) Source IP address of the FTP operation and VPN instance name and source
and destination port numbers of the FTP operation
5
Name or size of the uploaded file
6
Start mode and end mode of the test
6.7.2 Configuring the FTP Upload Test Parameters
This part describes how to set parameters for the FTP upload test.
Context
Do as follows on the NQA client (FTP client):
Procedure
Step 1
Run:
system-view
The system view is displayed.
Step 2
Run:
nqa
test-instance
admin-name
test-name
An NQA test instance is created and the test instance view is displayed.
Step 3
Run:
test-type
ftp
The test type is set to FTP.
Step 4
Run:
destination-address
ipv4
ip-address
The destination IP address is configured.
Step 5
(Optional) Perform the following as required to configure other parameters for the FTP upload
test:
l
To configure the source IP address, run the
source-address
ipv4
ip-address
command.
l
To configure the VPN instance to be tested, run the
vpn-instance
vpn-instance-name
command.
l
To configure the source port, run the
source-port
port-number
command.
l
To configure the destination port, run the
destination-port
port-number
command.
l
To configure the NQA test packet to be sent without searching the routing table, run the
sendpacket passroute
command.
Step 6
Run:
ftp-operation
put
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-16
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
