Data Preparation
To configure basic HGMP functions, you need the following data.
No.
Data
1
Range of private IP addresses used in the cluster
2
Cluster name
3
Medium access control (MAC) address of the member switch
4
(Optional) Aging time of NDP packets and interval for sending NDP packets
5
(Optional) Range of topology collection, hop delay and interface delay in forwarding
NTDP topology request packets, interval for topology collection
6
(Optional) ID of the management VLAN, aging time of NDP packets, interval for
sending handshake packets, address of the SNMP host, and IP addresses of the FTP
server and the SFTP server
8.2.2 Configuring NDP
This part describes how to configure the Neighbor Discovery Protocol (NDP) to collect
information about directly connected neighbors.
Procedure
l
Enabling NDP in the system view
Do as follows on the administrator switch and member switches:
1.
Run:
system-view
The system view is displayed.
2.
Run:
ndp enable
By default, NDP is not enabled in the system view.
l
Enabling NDP on an interface
Do as follows on the administrator switch and member switches:
1.
Run:
system-view
The system view is displayed.
2.
Run the following command as required:
–
Run:
ndp enable interface
{
interface-type
interface-number
[
to
interface-
type
interface-number
] }&<1-10>
NDP on an interface is enabled in the system view.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8 HGMP Configuration
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-9
