Hitachi HD6417032, Hardware Manual

Page: 38 / 690

3
Table 1.1 Features of the SH7032 and SH7034 Microcomputers (cont)
Feature Description
Interrupt controller Nine external interrupt pins (NMI,
IRQ0
–
IRQ7
)
(INTC)
Thirty-one internal interrupt sources
Sixteen programmable priority levels
User break controller
(UBC) Generates an interrupt when the CPU or DMAC generates a bus cycle
with specified conditions
Simplifies configuration of an on-chip debugger
Clock pulse generator
(CPG) On-chip clock pulse generator (maximum operating frequency: 20 MHz):
•
20-MHz pulses can be generated from a 20-MHz crystal with a duty
cycle correcting circuit
Bus state controller
(BSC) Supports external memory access:
•
Sixteen-bit external data bus
Address space divided into eight areas with the following preset features:
•
Bus size (8 or 16 bits)
•
Number of wait cycles can be defined by user.
•
Type of area (external memory area, DRAM area, etc.)

Simplifies connection to ROM, SRAM, DRAM, and peripheral I/O
•
When the DRAM area is accessed:

RAS
and
CAS
signals for DRAM are output

Tp cycles can be generated to assure RAS precharge time

Address multiplexing is supported internally, so DRAM can be
connected directly
•
Chip select signals (
CS0
to
CS7
) are output for each area
DRAM refresh function:
•
Programmable refresh interval
•
Supports CAS-before-RAS refresh and self-refresh modes
DRAM burst access function:
•
Supports high-speed access modes for DRAM
Wait cycles can be inserted by an external WAIT signal
One-stage write buffer improves the system performance
Data bus parity can be generated and checked