Hioki Memory HiCorder MR6000, Instruction Manual, Page: 123 / 392

117
5
Configuring the Trigger Settings
The trigger function allows you to start and stop measurement using specific signals. When
recording is started or stopped by specific signals, it is called “The instrument is triggered.”
When the real-time saving is set to [On] , you cannot use the trigger function.
In this chapter, the mark represents the point the start trigger is activated; the mark represents
the point the stop trigger is activated.
In the descriptions of each trigger source, the mark represents a point each trigger condition is
satisfied and a point each trigger is generated.
> [Trigger] > [Common]
Operation available on the [Trigger] screen
Configuring the logic trigger settings
(p. 138)
• Logic-trigger satisfaction conditions
• Trigger filter
•Trigger pattern
Configuring the analog trigger settings
(p. 129)
• Level trigger
• Window trigger
•Period trigger
•Glitch trigger
•Voltage drop trigger
Configuring the trigger setting
• Trigger timing (p. 120)
• Pre-trigger, post-trigger (p. 122)
•Trigger satisfaction condition (logical AND or OR
operation) among the trigger sources (p. 127)
Configuring the interval trigger settings
(p. 140)
Configuring the external trigger settings
(p. 142)
Forcible trigger (p. 142) CAN trigger (p. 143)
Configuring the trigger source settings
You can configure the trigger setting so that the instrument can output an signal from the external
control terminals when the trigger activates.
See “External trigger terminal (EXT.TRIG)” (p. 353).
5 Configuring the Trigger Settings
Configuring the
Trigger Settings
HIOKI MR6000A966-03