Hioki Memory HiCorder MR6000, Instruction Manual, Page: 144 / 392

138
Triggering the Instrument Using Logic Signals (Logic Trigger)
5.7 Triggering the Instrument Using Logic Signals
( Logic Trigger)
The section explains the logic trigger function.
• Input signals acquired across the logic channels serve as a trigger source.
• You can set a trigger pattern and trigger satisfaction condition by choosing between logical AND
and OR operations. When the logic-trigger conditions are satisfied, a logic trigger is generated.
• With the trigger filter setting, no logic triggers are generated until the logic-trigger condition is
continuously satisfied during the specified filter.
> [Trigger] > [Source]
1
3
2
1
Tap the [Condition satisfied] box, and then choose a logic-trigger satisfaction condition from
the list.
Off  Disables the logic trigger.
OR The logic-trigger condition is satisfied when any one of logic input signals matches the
trigger pattern.
AND The logic-trigger condition is satisfied when all logic input signals match the trigger
pattern.
2
Tap the [ Filter] box, and then choose a sampling count of the filter from the list.
Only after the level-trigger condition is continuously satisfied during the specified period, an analog trigger is
generated.
Configuring the trigger filter setting prevents a logic trigger from being unintentionally generated due to noise.
(p. 131)
Off  Disables the trigger filter.
10 to 10000 Enables the trigger filter.
Allows you to enter a filter width in the number of samples.
When the envelope is used
Off  Disables the trigger filter.
1 ms , 10 ms Enables the trigger filter.
HIOKI MR6000A966-03