Hioki Memory HiCorder MR6000, Instruction Manual, Page: 78 / 392

72
Configuring Module-Specific Settings
10
Tap the [Smoothing] box, and then choose a scaling setting from the list.
Only when
[Mode]
is set to
[Freq]
or
[Revolution]
, this setting is available.
Off  Records measured data without smoothing (resulting in a step-like waveform).
On
Interpolates measured data to smooth a waveform and outputs it.
(Upper limit: 10 kHz; outputting data with this setting set to on lags behind that with this
setting set to off)
11
Tap the [Hold] box, and then choose a measured-value retaining setting from the list.
Only when [Mode] is set to [Freq] or [Revolution] , this setting is available.
Off (1 Hz) ,
Off (0.5 Hz) ,
Off (0.2 Hz) ,
Off (0.1 Hz)
When the instrument cannot determine a measured value even when the frequency
reaches a value in the brackets, the instrument determines the measurement to stop
and regards the measured value as 0 Hz (0 rpm).
On

Retains the value confirmed the last time.
12
Tap [Close] .
The setting dialog box closes.
HIOKI MR6000A966-03