Hioki Memory HiCorder MR6000, Instruction Manual, Page: 23 / 392

17
Configuring the Input Channel Settings
Logic channels
The logic sheet appears when the screen is in Single, Dual, Quad, Octa, or Hexadeca mode.
> [Channel]
The instrument displays the waveform screen when a logic
channel is chosen. You can check display positions of the logic
signals.
2
3
1
4
1
Tap the [Use] button to set it to [On] or [Off] .
On  Measures a waveform through this module.
Off Does not measure any waveform through this module.
Since no data is acquired, the instrument displays or saves nothing.
2
Tap the [Logic width] box, and then choose a display width for logic waveforms from the list.
Making waveforms narrower can enhance the readability of a display that contains a large number of
waveforms.
This setting is a cross-module for all logic modules installed in the instrument.
Wide
Increases the width of the waveforms.
Normal  Displays the waveforms in normal width.
Narrow Reduces the width of the waveforms.
3
Choose a display method for each probe (LA through LD).
Position Allows you to specify a numeral that represents a logic waveforms position on the
screen in one percent point increments.
This setting is a cross-probe for all probes (LA through LD).
You can display logic waveforms in a desired position.
Display Allows you to choose whether to display logic waveform.
Color Allows you to choose a display waveform of each waveform. You can also choose the
same color as the lines acquired across other channels.
Comment Allows you to type a comment for each channel.
Number of characters that can be entered: up to 40
Measurement Method
HIOKI MR6000A966-03