Hioki Memory HiCorder MR6000, Instruction Manual, Page: 183 / 392

177
Evaluating Calculation Results on a Pass/Fail Basis
7.3 Evaluating Calculation Results on a Pass/Fail
Basis
You can specify evaluation criteria ( [Up] and [Low] ) to evaluate numerical calculation results on a
pass/fail basis.
Each numerical calculation can has different evaluation criteria.
The waveform acquisition process varies depending on the recording mode setting ( [Single] or
[Repeat] ) and the stop condition specified to stop measurement according to an evaluation ( [PASS] ,
[FAIL] , or [PASS & FAIL] ).
Configuring the calculation
settings
Starting a measurement
Acquiring data
Performing calculations
Displaying calculation
results
Evaluating calculation
results
Saves data.
Finishing the measurement
Stop condition
Recording mode
No stop condition
is satisfied.
A stop condition is satisfied,
or stop condition is set to
[PASS & FAIL] .
[Repeat]
[Single]
Measurements repeat
until the stop condition is
satisfied.
Measurement repeats
until the
STOP
key is
pressed.
Automatic saving is not carried out until the stop condition is satisfied at the end of calculation
evaluation.
Numerical Calculation Function
HIOKI MR6000A966-03