Hioki Memory HiCorder MR6000, Instruction Manual, Page: 243 / 392

237
Setting FFT Calculation Conditions
When the recording mode is set to [Repeat]
The instrument continues the measurement even if the waveform acquisition count has reached the
number specified in the
[Averaging Number]
box.
When the waveform acquisition count reaches, the instrument re-executes the averaging process
and repeats measurements until you press the
STOP
key.
Starting a measurement
Acquiring data When a trigger condition is satisfied, the instrument
starts to acquire data.
(If no trigger setting is configured, pressing the START key
allows the instrument to start to acquire data.)
FFT calculation The instrument clips off a data set that contains a specified
points, and processes the data set through the FFT.
The message [Calculating] appears on the status bar of the
screen.
Averaging The instrument executes the averaging process.
Displaying calculation
results
The instrument displays results on the waveform screen.
(Saving results) The instrument with the automatic saving set to [On] saves
data every time.
When the waveform acquisition count has not reached the
specified number, the instrument repeats acquisitions of
waveforms.
When the waveform acquisition count has reached the
specified number, the instrument re-executes the averaging
process, and then repeats acquisitions of waveforms.
Finishing the
measurement
The instrument repeats measurements until you press the
STOP key.
If you stop the measurement before the count has not been
reached the specified number, the instrument displays an
averaging result up to that point.
FFT
Calculation Function
HIOKI MR6000A966-03