5.1 Comparator Function
74
Outputting Judg-
ment Results
• Output the judgment result for each of C and D (LO/IN/HI) and the AND
results for both judgment results (only when both parameters are IN) from
EXT I/O.
See
7.1 "About the EXT I/O Connector" (p. 123)
• The comparator judgment results (IN/NG) can be differentiated by beep tones.
See
6.9 "Setting Beep Tones" (p. 112)
• Except for the trigger setting, the measurement conditions cannot be changed
in comparator measurement mode.
Press
to switch to normal measurement mode and then change the
measurement conditions.
Keys Enabled for
Comparator Mode
Key
Function
Switches the measurement mode.
Switches to the setting modes for the upper limit and lower
limit values.
Change to confirm the upper/ lower limit values, range, and
voltage current monitor values.
Switches the trigger setting to INT/EXT.
This key is only enabled when the trigger setting is EXT. One
measurement is performed each time the key is pressed.
The following menu settings can be made.
• “LoAd_A(C/h)”
• “SAVE”
• “Ld_tYP”
• “Cont”
• “Lo C”
• “LEV.ChK”
• “bEEP_K”
• “dISP”
• “IF”
Settings other than the above listed can be made from normal
measurement mode.
Menu which cannot be set at the comparator measurement
mode will display the current setting conditions in the lower
portion of the MAIN display.
Changes the keylock function and cancels the remote state.
Summary of Contents for 3504-40 C HiTester
