Hioki 3504-40 C HiTester, Instruction Manual

Page: 65 / 292

4.4 Self Calibration
59
4
Performing Self Calibration ______________________________________
1.
In normal measurement mode, press .
The upper part of the MAIN display area displays the menu contents and the
lower part displays the setting information.
(Refer to "Menu display organization" (p. 13) for menu order)
This setting cannot be changed in comparator mode and BIN mode.
2.
Use or to select the “CALIb” menu item.
3.
Use and to select a setting item.
Pressing or causes the display to change in the following manner 。
4.
Press .
The Self calibration setting is confirmed.
After confirmation, "IF" (Communication conditions setting screen) is dis-
played at the top of the MAIN display area.
The Self calibration setting is not confirmed unless is pressed.
5.
Press .
(Self calibration settings screen)
Menu content
Self calibration
(set in step 3)
(MAIN display area)
“ MAnu ”
When inputting the trigger from EXT I/O and when the
CALIB signal line is at LOW, the self calibration value
will be calculated and adjusted during measurement.
Or when communication command (:CALibration:ADJust)
is executed, self calibration value will be calculated and
adjusted at the point of the first measurement after a
request for start.
“
Auto ”
Self calibration value will be calculated and adjusted
during each measurement.
“ oFF ”
Adjust using the factory default self calibration value.